2D Table using 8051
Discussion in "Project Addition or Changes" started by DruvaN Jun 30, 2017.
Fri Jun 30 2017, 02:48 pm
Hi,
I wanna build my own 2D table using 8051 (At89s52) and two servo (1.8Degree/Steps).
but i am getting a straight line instead of a circle. help me out
I wanna build my own 2D table using 8051 (At89s52) and two servo (1.8Degree/Steps).
but i am getting a straight line instead of a circle. help me out
Sun Jul 02 2017, 02:29 am
You need to post your code so far and more information about your hardware.
Tue Jul 04 2017, 10:17 am
Can you post image of what output are you getting? You might have to do micro-stepping if precise control is needed.
Powered by e107 Forum System
Lewisuhakeply
Thu Apr 18 2024, 06:00 pm
Darrellciz
Thu Apr 18 2024, 11:07 am
Charlessber
Thu Apr 18 2024, 09:29 am
BartonSem
Thu Apr 18 2024, 04:56 am
DonaldKnown
Thu Apr 18 2024, 12:24 am
utaletxcyw
Wed Apr 17 2024, 10:21 am
Anthonyvab
Wed Apr 17 2024, 08:48 am
RobertCix
Wed Apr 17 2024, 06:46 am