Discussion in "General help Guidance and Discussion" started by    adithyapaip    Jul 21, 2016.
Thu Jul 21 2016, 11:36 pm
#1
Hi Guys..
i have a 8051 programmer which has 4mhz crystal used usually helps in uploading programmer,but my actual project uses 11.0592mhz. so if i use progammer with 4mhz crystal to burn the program but project uses 11.0592mhz so can i replace programmer crystal of 4mhz to 11.0592mhz..and if not how to substitute it because if i replace project crystal as 4mhz so that i can match with crystal the program delay and other many parameters will alter and i have to re program it thanks in advance.....
Fri Jul 22 2016, 12:34 am
#2
The crystal on the programmer does not affect the final project.
Don't change it.
Fri Jul 22 2016, 12:48 am
#3
I am using keil to do everthing in 8051,when I was selecting as usual 11.0592mhz while creating hex file and uploading but it was not working simple led blink also , after lots of debugging i found the programmer which I bought has uses 4mhz crystal so I created hex file using that frequency and uploaded it bingo I got the output so I hope my above question and this helps....
Fri Jul 22 2016, 01:07 am
#4
That is curious, but very likely a co-incidence.
The original problem was probably fixed during your debugging period.

Try your test code at other frequencies , then at 11.0592mhz again.

Get Social

Information

Powered by e107 Forum System

Downloads

Comments

Bobbyerilar
Thu Mar 28 2024, 08:08 am
pb58
Thu Mar 28 2024, 05:54 am
Clarazkafup
Thu Mar 28 2024, 02:24 am
Walterkic
Thu Mar 28 2024, 01:19 am
Davidusawn
Wed Mar 27 2024, 08:30 pm
Richardsop
Tue Mar 26 2024, 10:33 pm
Stevencog
Tue Mar 26 2024, 04:26 pm
Bernardwarge
Tue Mar 26 2024, 11:15 am