interfacing sm20 finger print module with lpc2148

hello sir,i have a sm20 finger print module and i want to write an application for interfacing sm20 module with lpc2148 but plz tell me how to check my sm20 finger print module is working or not??? i have serial port terminal software..

I found this data sheet that seems to cover your model.
As commands are 24 bytes long and not in ASCII you can't do a simple test.
Write a program to send a command string and check the reply.

thanku sir my module is working

but there is one issue i used lpc2148 trainer board for interfacing fp..in that pin.0.8 showing 0 voltage and i cant get proper response from fp

pin 0.8 and pin 0.9 are used for receive and transmit data for UART1....and i used UART0 for transmitting data and uart1 used for showing response from fp....

but there is one issue i used lpc2148 trainer board for interfacing fp..in that pin.0.8 showing 0 voltage and i cant get proper response from fp

sachinmm

Are you still having problems ?

yes sir..

because FP data is reading by using UART1 and TX AND RX pin of uart1 is connected to pin0.8 & pin0.9 and TX show 0 volt.

Can you give a link to the lpc2148 trainer board you are using.

Are you able to program the board to do anything ?
Do you have any demo software that transmits on UART1 ?

[Topic moved to ARM Development Forum]